Hello and Welcome. Below is the Ross Adventurer as I found it.
Check-Out the blogs NEW Face-Book page! And Please click on "Like" to show your support. To do so now just click on the LOGO ~~~~~~>
Above: Judging by the lack of wear to the original equipment, my best guess would be that this bike was ridden a few times and then parked. The pristine condition of the frame and paint made this bike a "near perfect" candidate for a single to three piece crank conversion. Although I would have preferred a better quality American ten-speed. However this bike did give me the opportunity to make several improvements because it IS such a low-level bike.
Above: This is about as cheap of a stem as you will find anywhere. It is a rolled steel, chrome plated stem. Typical original equipment on a cheap department store retro-cruiser bicycle. The drop bars were also cheap and heavy steel chrome plated, also department store quality. The handlebars had foam covers instead of handlebar tape. Very popular in the 1980`s. (when I was riding motorcycles) I pretty much missed the whole foam handlebar wrap era. (lucky me) The original Shimano shift levers were plastic. And finally the brake levers were such cheaply made generics that the manufacturer did not bother putting their name on them. (probably a wise choice) So basically the original stem and everything attached to it was garbage. (even by "Department-Store Bike" standards)
Above: Here we have the reconditioned SR stem installed with Ross engraved lighter weight handlebars. (bars off a Ross Carrera) The Brake-levers are vintage "Schwinn Approved" with the quick release feature. The tape is white Avenir basic cork tape (nicely padded) The slightly over-sized stem-mount alloy shifters are vintage Shimano of a much higher level. I also replaced the front head-mount reflector bracket with a cable-guide bracket for the center-pull caliper brake.
Above: A Ross "plastic mount" (no rails) saddle. I have only seen these on other Ross bikes of the same era and also once on a TONKA "tyke-bike". Do I really need to say anything more, like what a POS I think this saddle is.
Above: The Origin 8 "Aero" Saddle is the cheapest white saddle I could find. And in my opinion, it is still a huge improvement. Because of what this bike is, I have to watch every penny. No matter how many changes and improvements I make, it is still a Ross Adventurer. And I`m only going to get so much for it when it is sold.
Above: I took the rear brake cable-guide off the upcoming Schwinn Varsity project bike. Apparently the Schwinn Varsity also received a brake caliper up-grade at some point along it`s journey. I`m hoping I have another rear brake-cable guide stashed-away somewhere. As you can see the caliper arms are just barely long enough for the shoes to clear the tire. I may still trim-off about 1/8th inch of rubber from the top corners edges of the brake-shoes.
Above: As it turned-out, the Ross Carrera came with the exact same Shimano derailleurs that are on the Ross Adventurer. Both front and rear derailleurs received a good cleaning, lube and adjustment.(Clean-Streak and Tri-Flo)
Above: The finished project. The Ross Adventurer now sports a reconditioned set of "Continental Style" pedals. And a new Schwinn chain as well. The paint touched-up "the wee bit that there was" has been completed at this point.
Above: The left side of the bike. I do have a better Avenir alloy kick-stand for the bike. Here it is shown with the original kick-stand. I regret the weather has not cooperated and I have not been able to take any pics out of doors.
Above: One last shot of the three piece crank with the front derailleur all cleaned-up and mounted and with the new Schwinn chain in place. I only regret that I could not find a matching set of lighter wheels laying around the shop. But due to the value (or lack of value)of this bike, it was just not worth purchasing even a cheap new aluminum wheel-set. Had it been a "keeper" or a "build to order bike" then maybe I could have made the wheel change.
We have had our first taste of winter for this season. For those of you who live in warmer climates. When the rain turns to snow, the snow sticks to the trees. To see an entire forest painted white with snow in the morning light is a beautiful thing to behold. It did however knock-out the power which also knocked out the well and the boiler. Fortunately the power was not out as long as expected. And we got through it just fine.
Above: All I know about this bike, is that it once belonged to the Schwinn family. I just thought you might enjoy seeing it. Till next time, Please RIDE SAFE and remember to Always RESCUE, RESTORE & RECYCLE
Cheers, Hugh
No comments:
Post a Comment